Tuesday, November 5, 2013

How to install DDR1 RAM in Pentium 4 Motherboard (Funny) (Hindi) (720p HD)



RAM is sensitive to static charges and should be handled carefully. Never touch the metal conductors and only handle RAM by their edges. 

Depending on its architecture, there will always be at least one notch in a RAM, but never more than two.

RAM modules are keyed with little notches that fit over corresponding tabs in the RAM slots. Before inserting the RAM module, make sure that the notches and tabs are correctly lined up.

Installing RAM is easy to do and probably the easiest task in building a computer.

There will be one or two indentations on your RAM (depending on type of RAM). These indentations need to face the notches on the RAM slots. Now take the RAM carefully and push them into RAM slot, the little RAM clicks should snap into place.

If the BIOS screen comes up on your monitor and there is not a series of beepings then your RAM is successfully installed. To check if all your RAM is recognized by your computer, then you need to go to the BIOS setup, which will display the amount of RAM that is recognized.

This video can be useful for a new user who wants to change their DDR1 RAM in their Pentium computers. Same steps are applicable for installing new type of RAM (DDR2 or DDR3) in their respective Motherboards. (Voice : Hindi) 

The dialogue of this video is little humorous and has touch of a cricket match commentary.

Thursday, August 1, 2013

How to Install Internal Hard Drives : IDE Hard Drive Connectors



Learn how to connect IDE hard drives, and other tips for installing hard drives on computers.

How to install IDE Harddisk in Pentium Computer (Hindi) (720p HD)



Watch out easy steps to connect IDE hard drive and IDE DVD Rom with Pentium based motherboards. You have to connect carefully IDE Data cable (from Pentium Motherboard) and power cable {from Power Supplier (SMPS) of Computer} to IDE based Hard drive and DVD Rom. An IDE Cable has 36 holes in their ribbon cable end. We have to install this ribbon cable end properly in our IDE HDD and DVD Rom with care so that it does not break any pin located in our IDE devices. Some time, breakage of any important pin can cause malfunction in detection of our IDE devices by the computer system. Similarly, power cables have four colour wires attached to their cable end. They have four holes and can be attached to power pines provided in IDE devices. You can watch how to connect IDE data cable and power cable to IDE Devices in this video. This video can be useful for a new user who wants to change their IDE based Drives in their Pentium computers. (Voice : Hindi) 

Wednesday, July 17, 2013

Meet Gmail's New Inbox



New customizable tabs put you back in control so that you can see what's new at a glance and decide which emails you want to read and when.
Related Posts Plugin for WordPress, Blogger...